Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006COBALT SS, 4D SEDAN, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 853 (SHIFT INTERLOCK SYSTEM)DIAGNOSTIC INFORMATION AND PROCEDURESTRANSMISSION CONTROL LEVER MALFUNCTIONCOMPONENT TESTING
2006 Chevrolet Cobalt SS, 4D Sedan, Standard
Component Testing
2006 Chevrolet Cobalt SS, 4D Sedan, StandardSECTION Component Testing
WARNING: This page is about a different car, the 2010 Pontiac G5 and 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
- Install a 10A fused jumper wire between the control circuit terminal A and 12 volts. Install a jumper wire between the transmission shift select switch (park) signal circuit terminal B and ground.
- Listen for the solenoid to turn ON and OFF.
- If the function does not perform as specified, replace the shift lock actuator.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.