SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006COBALT SS, 4D SEDAN, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 840 (ENGINE CONTROLS AND FUEL - 2.2L - REPAIR INSTRUCTIONS)REPAIR INSTRUCTIONSAIR CLEANER ASSEMBLY REPLACEMENTINSTALLATION PROCEDURE
2006 Chevrolet Cobalt SS, 4D Sedan, Standard

Installation Procedure

2006 Chevrolet Cobalt SS, 4D Sedan, StandardSECTION Installation Procedure
WARNING: This page is about a different car, the 2010 Pontiac G5 and 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Air Cleaner Nuts
    GM1657015Courtesy of GENERAL MOTORS CORP.
  1. Install the air cleaner, push down the front leg of the housing in order to seat the housing onto the stud.
    2. CAUTION: Refer to Fastener Caution .
  2. Install the air cleaner nuts and tighten to 10 N.m (89 lb in).
    3. Fig 2: View Of Engine Harness Electrical Connector To MAF/IAT Sensor
    GM1647998Courtesy of GENERAL MOTORS CORP.
  3. Install the air cleaner outlet duct. Refer to Air Cleaner Outlet Duct Replacement .
  4. Connect the engine harness electrical connector to the MAF/IAT sensor.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.