Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006COBALT SS, 4D SEDAN, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 84 (STEERING WHEEL & STEERING COLUMN)
2006 Chevrolet Cobalt SS, 4D Sedan, Standard
Section 84 (Steering Wheel & Steering Column)
2006 Chevrolet Cobalt SS, 4D Sedan, StandardSECTION Section 84 (Steering Wheel & Steering Column)
WARNING: This page is about a different car, the 2005 Buick LaCrosse and 2005 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
- Specifications
- Schematic and Routing Diagrams
- Component Locator
- Diagnostic Information and Procedures
- Repair Instructions
- Seal Replacement - Intermediate Steering Shaft
- Intermediate Steering Shaft Replacement
- Steering Column Accident Damage Inspection
- Steering Column Trim Covers Replacement (Manual Tilt)
- Ignition Switch Replacement
- Ignition Lock Cylinder Replacement
- Ignition Lock Cylinder Case Replacement
- Turn Signal Cancel Cam and Steering Shaft Upper Bearing Spring Replacement
- Multifunction, Turn Signal Switch Replacement
- Turn Signal Switch Housing Replacement
- Shift Lever Replacement
- Linear Shift Assembly Replacement
- Tilt Lever Replacement
- Steering Wheel Control Switch Assembly Replacement
- Steering Wheel Replacement
- Tilt Spring Replacement
- Steering Column Tilt Head Replacement
- Steering Column Replacement
- Steering Shaft, Lower Bearing, and Jacket Replacement
- Wire Harness Assembly Replacement (Manual Tilt Column)
- Inflatable Restraint Steering Wheel Module Coil Centering
- Description and Operation
- Special Tools and Equipment
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.