Fastener Tightening Specifications

2006 Chevrolet Cobalt SS, 4D Sedan, StandardSECTION Fastener Tightening Specifications
WARNING: This page is about a different car, the 2010 Pontiac G5 and 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
Application Specification
Metric English
Brake Pipe Fitting 19 N.m 14 lb ft
Brake Pressure Modulator Valve (BPMV) to Mounting Bracket Bolt 11 N.m 97 lb in
BPMV Mounting Bracket Bolt 25 N.m 18 lb ft
BPMV Mounting Pin 10 N.m 89 lb in
Electronic Brake Control Module (EBCM) Bolt (With JL4) 3 N.m 27 lb in
EBCM Bolt (Without JL4) 2.3 N.m 20 lb in
Engine Control Module (ECM) Bracket and BPMV Bracket Mounting Bolt 12 N.m 106 lb in
Yaw Rate Sensor Nut 10 N.m 89 lb in
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.