SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006COBALT SS, 4D SEDAN, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 819 (WIPER SYSTEM & WASHER SYSTEM)REPAIR INSTRUCTIONSWINDSHIELD WIPER TRANSMISSION REPLACEMENTINSTALLATION PROCEDURE
2006 Chevrolet Cobalt SS, 4D Sedan, Standard

Installation Procedure

2006 Chevrolet Cobalt SS, 4D Sedan, StandardSECTION Installation Procedure
WARNING: This page is about a different car, the 2010 Pontiac G5 and 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the wiper motor to the wiper transmission. Refer to Windshield Wiper Motor Replacement .
  2. Connect the electrical connector to the wiper motor.
    3. Fig 1: View Of Wiper Module Assembly
    GM1655547Courtesy of GENERAL MOTORS CORP.
  3. Install the wiper transmission into the plenum.
    4. CAUTION: Refer to Fastener Caution .
  4. Install the fasteners (1) attaching the wiper transmission assembly (2) to the plenum. Tighten the fasteners in sequence as shown to 10 N.m (89 lb in)
  5. Install the air inlet grille panel. Refer to Air Inlet Grille Panel Replacement .
  6. Install the wiper arms. Refer to Windshield Wiper Arm Replacement .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.