SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006COBALT SS, 4D SEDAN, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 807 (LIGHTING SYSTEM)REPAIR INSTRUCTIONSREAR SIDE MARKER LAMP REPLACEMENT
2006 Chevrolet Cobalt SS, 4D Sedan, Standard

Rear Side Marker Lamp Replacement

2006 Chevrolet Cobalt SS, 4D Sedan, StandardSECTION Rear Side Marker Lamp Replacement
WARNING: This page is about a different car, the 2010 Pontiac G5 and 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Rear Side Marker Lamp (Pontiac G5)
GM2018003Courtesy of GENERAL MOTORS CORP.
Callout Component Name
1 Rear Side Marker Lamp Screw
CAUTION: Refer to Fastener Caution .

Tighten:  2.5 N.m (22 lb in)
2 Rear Side Marker Lamp Housing

Procedure

  1. Pull the rearward edge of the lamp away from the rear bumper fascia in order to release the front tab.
  2. Rotate the electrical bulb socket harness counter-clockwise and remove from the lamp housing.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.