SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006COBALT SS, 4D SEDAN, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 807 (LIGHTING SYSTEM)REPAIR INSTRUCTIONSHIGH MOUNT STOP LAMP REPLACEMENT
2006 Chevrolet Cobalt SS, 4D Sedan, Standard

High Mount Stop Lamp Replacement

2006 Chevrolet Cobalt SS, 4D Sedan, StandardSECTION High Mount Stop Lamp Replacement
WARNING: This page is about a different car, the 2010 Pontiac G5 and 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: View Of High Mounted Stop Lamp (Sedan)
GM1549048Courtesy of GENERAL MOTORS CORP.
Callout Component Name

Preliminary Procedure

  1. Remove the rear compartment lid inner panel trim. Refer to Rear Compartment Lid Inner Panel Trim Replacement .
  2. Disconnect the electrical harness from the bulb assembly connector.
1 High Mount Stop Lamp Nut (Qty: 2)
CAUTION: Refer to Fastener Caution .

Tighten:  4.5 N.m (40 lb in)
2 High Mount Stop Lamp
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.