Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006COBALT SS, 4D SEDAN, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 807 (LIGHTING SYSTEM)DIAGNOSTIC INFORMATION AND PROCEDURESDTC C0277DTC DESCRIPTORS
2006 Chevrolet Cobalt SS, 4D Sedan, Standard
DTC Descriptors
2006 Chevrolet Cobalt SS, 4D Sedan, StandardSECTION DTC Descriptors
WARNING: This page is about a different car, the 2010 Pontiac G5 and 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
- DTC C0277 06
-
Brake Pedal Position Sensor Circuit Short to Ground or Open
- DTC C0277 07
-
Brake Pedal Position Sensor Circuit Voltage Above Threshold
- DTC C0277 09
-
Brake Pedal Position Sensor Circuit Rate of Change Above Threshold
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.