SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006COBALT SS, 4D SEDAN, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 801 (FIXED AND MOVEABLE WINDOWS SYSTEM)REPAIR INSTRUCTIONSFRONT SIDE DOOR WINDOW REGULATOR REPLACEMENT (POWER SEDAN)
2006 Chevrolet Cobalt SS, 4D Sedan, Standard

Front Side Door Window Regulator Replacement (Power Sedan)

2006 Chevrolet Cobalt SS, 4D Sedan, StandardSECTION Front Side Door Window Regulator Replacement (Power Sedan)
WARNING: This page is about a different car, the 2010 Pontiac G5 and 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: View of Front Side Door Window Regulator
GM1686908Courtesy of GENERAL MOTORS CORP.
Callout Component Name

Preliminary Procedures

  1. Remove the front side door trim panel. Refer to Front Side Door Trim Panel Replacement .
  2. Remove the water deflector. Refer to Front Side Door Water Deflector Replacement .
1 Front Side Door Window Regulator Bolts (Qty: 5)
CAUTION: Refer to Fastener Caution .

Procedures

  1. Place the window in the full up position.
  2. Tape the window to the door upper door frame.
  3. Disconnect the electrical connector.

Tighten:  10 N.m (89 lb in)
2 Front Side Door Window Regulator

Procedures

  1. Push in on each end of the window insulators retainer clips.
  2. Slide the sash forward releasing the window retainer clips from the window.
  3. Inspect the window for proper operation before installing the door trim panel.

Tip:  Do not remove the sash from the window regulator.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.