Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006COBALT SS, 4D SEDAN, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 801 (FIXED AND MOVEABLE WINDOWS SYSTEM)DIAGNOSTIC INFORMATION AND PROCEDURESPOWER WINDOWS MALFUNCTION (SEDAN)COMPONENT TESTINGFRONT PASSENGER WINDOW SWITCH
2006 Chevrolet Cobalt SS, 4D Sedan, Standard
Front Passenger Window Switch
2006 Chevrolet Cobalt SS, 4D Sedan, StandardSECTION Front Passenger Window Switch
WARNING: This page is about a different car, the 2010 Pontiac G5 and 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition OFF, disconnect the harness connector at the passenger window switch.
- Test for infinite resistance between the control terminals G and F and the ignition terminal A with the switch in the INACTIVE position.
- If less than the specified value, replace the passenger window switch.
- Test for less than 2 ohms between the control terminal G and the ignition terminal A with the switch in the UP position.
- If greater than the specified range, replace the passenger window switch.
- Test for less than 2 ohms between the control terminal F and the ignition terminal A with the switch in the DOWN position.
- If greater than the specified range, replace the passenger window switch.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.