SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006COBALT SS, 4D SEDAN, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 751 (ENGINE ASSEMBLY)TORQUE ROD BRACKET REPLACEMENT
2006 Chevrolet Cobalt SS, 4D Sedan, Standard

Torque Rod Bracket Replacement

2006 Chevrolet Cobalt SS, 4D Sedan, StandardSECTION Torque Rod Bracket Replacement
WARNING: This page is about a different car, the 2011 Honda Insight and 2010 Honda Insight. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise the vehicle on the lift to full height.
  2. Support the transmission with a jack and a wood block under the transmission.
  3. Remove the torque rod (A).
    Fig 1: Identifying Torque Rod
    G06428842Courtesy of AMERICAN HONDA MOTOR CO., INC.
  4. Remove the torque rod bracket (A).
    Fig 2: Torque Rod Bracket With Torque Specifications
    G06428843Courtesy of AMERICAN HONDA MOTOR CO., INC.
  5. Install the torque rod bracket.
  6. Install the torque rod (A).
    NOTE: Be sure to install the torque rod with the "UP" mark facing up.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.