Add one new key/Keyless transmitter

2006 Chevrolet Cobalt SS, 4D Sedan, StandardSECTION Add one new key/Keyless transmitter
WARNING: This page is about a different car, the 2011 Honda Insight and 2010 Honda Insight. However, it is still accessible from the selected car via links, so may be relevant.
  1. Have a registered key, a new immobilizer key, and the first password from the iN system.
  2. Connect the HDS to the data link connector.
  3. Turn the ignition switch to ON (II).
  4. Select IMMOBI from the System Selection Menu, then select the IMMOBILIZER SETUP menu.
  5. Select Add and Delete keys, then Add 1 key.
  6. Do the registration according to the instructions on the HDS screen.
  7. Check if the engine can be started with the newly registered key.
  8. When prompted by the HDS, do the keyless transmitter programming.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.