SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006COBALT SS, 4D SEDAN, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 734 (INTAKE AIR SYSTEM)AIR CLEANER REMOVAL/INSTALLATION
2006 Chevrolet Cobalt SS, 4D Sedan, Standard

Air Cleaner Removal/Installation

2006 Chevrolet Cobalt SS, 4D Sedan, StandardSECTION Air Cleaner Removal/Installation
WARNING: This page is about a different car, the 2011 Honda Insight and 2010 Honda Insight. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the clips (A).
    Fig 1: MAF Sensor/IAT Sensor Connector And Air Cleaner Element With Torque Specifications
    G06429569Courtesy of AMERICAN HONDA MOTOR CO., INC.
  2. Disconnect the MAF sensor/IAT sensor connector (B), then remove the air cleaner housing cover (C), and the air cleaner element (D).
    NOTE: Be careful not to damage the MAF sensor/IAT sensor on the air cleaner housing cover.
  3. Remove the air cleaner housing (A).
    Fig 2: Identifying Air Cleaner Housing
    G06429570Courtesy of AMERICAN HONDA MOTOR CO., INC.
  4. Install the parts in the reverse order of removal.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.