Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006COBALT SS, 4D SEDAN, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 723 (IMA SYSTEM)IMA MOTOR HOUSING REMOVAL/INSTALLATION
2006 Chevrolet Cobalt SS, 4D Sedan, Standard
IMA Motor Housing Removal/Installation
2006 Chevrolet Cobalt SS, 4D Sedan, StandardSECTION IMA Motor Housing Removal/Installation
WARNING: This page is about a different car, the 2011 Honda Insight and 2010 Honda Insight. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the IMA motor rotor (see IMA MOTOR ROTOR REMOVAL/INSTALLATION ).
- Remove the connector (A) and the bracket (B).
- Remove the bolt (C) and the IMA motor housing (D).NOTE: Set the dowel pins (E) in the IMA motor housing before installing the motor stator on the engine.
- Install the parts in the reverse order of removal.
- Install the IMA motor rotor (see IMA MOTOR ROTOR REMOVAL/INSTALLATION ).
- Do the motor rotor position calibration procedure (see IMA MOTOR ROTOR POSITION CALIBRATION ).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.