Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006COBALT SS, 4D SEDAN, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 72 (LIGHTING SYSTEMS)REPAIR INSTRUCTIONSCOURTESY LAMP REPLACEMENT - OVERHEAD CONSOLE (WITHOUT SUNROOF)
2006 Chevrolet Cobalt SS, 4D Sedan, Standard
Courtesy Lamp Replacement - Overhead Console (without Sunroof)
2006 Chevrolet Cobalt SS, 4D Sedan, StandardSECTION Courtesy Lamp Replacement - Overhead Console (without Sunroof)
WARNING: This page is about a different car, the 2005 Buick LaCrosse and 2005 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
Courtesy Lamp Replacement - Overhead Console (without Sunroof)
| Callout | Component Name |
|---|---|
|
NOTE:
Refer to Fastener Notice
in Cautions and Notices. Fastener Tightening Specifications:
Refer to Fastener Tightening Specifications . |
|
| 1 | Lens, Reading Lamp Tip:
|
| 2 | Screw, Roof Console (Qty: 3) Tighten: 2 N.m (18 lb in) |
| 3 | Lamp Assembly, Roof Console Courtesy and Reading Tip: Disconnect the electrical connectors. |
| 4 | Retainer, Backing Plate Tip: The headliner must be lowered to remove the backing plate retainer. Refer to Headliner Replacement . |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.