Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006COBALT SS, 4D SEDAN, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 704 (ENGINE CONTROL SYSTEM & FUEL SYSTEM - 2.4L - DTC P0010 TO DTC P0366)DTC P0335 OR P0336COMPONENT TESTING
2006 Chevrolet Cobalt SS, 4D Sedan, Standard
Component Testing
2006 Chevrolet Cobalt SS, 4D Sedan, StandardSECTION Component Testing
WARNING: This page is about a different car, the 2008 Pontiac G5 and 2008 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
You must perform the Circuit/System Testing before proceeding with Component Testing.
- Remove the CKP sensor and inspect the sensor and the O-ring for damage.
- Connect the connector to the CKP sensor.
- Ignition ON, engine OFF, observe the CKP Active Counter while passing a steel object by the tip of the sensor repeatedly. The CKP Active Counter should increment.
- If the CKP Active Counter does not increment, replace the CKP sensor.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.