Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET2006COBALT SS, 4D SEDAN, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 7 (LIGHTING SYSTEMS)REPAIR INSTRUCTIONSDOOR LAMP REPLACEMENTREMOVAL PROCEDURE

2006 Chevrolet Cobalt SS, 4D Sedan, Standard

Removal Procedure

2006 Chevrolet Cobalt SS, 4D Sedan, StandardSECTION Removal Procedure

WARNING: This page is about a different car, the 2005 Saturn L300. However, it is still accessible from the selected car via links, so may be relevant.

Right front door shown. The rest of the doors are similar.

Fig 1: Removing & Installing Door Lamp

Courtesy of GENERAL MOTORS CORP.

Insert a flat-bladed tool as shown in graphic.
Remove the lens.
Remove the bulb.
Remove the lamp housing and disconnect the wire connector.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.