Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006COBALT SS, 4D SEDAN, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 7 (LIGHTING SYSTEMS)COMPONENT LOCATORLIGHTING SYSTEMS COMPONENT VIEWS
2006 Chevrolet Cobalt SS, 4D Sedan, Standard
Lighting Systems Component Views
2006 Chevrolet Cobalt SS, 4D Sedan, StandardSECTION Lighting Systems Component Views
WARNING: This page is about a different car, the 2005 Saturn L300. However, it is still accessible from the selected car via links, so may be relevant.
| Callout | Component Name |
|---|---|
| 1 | Daytime Running Lamp (DRL) Resistor |
| 2 | G103 |
| Callout | Component Name |
|---|---|
| 1 | Headlamp/Turn Signal Switch |
| 2 | Instrument Panel Cluster (IPC) |
| 3 | Vanity Lamps |
| 4 | Courtesy/ Reading Lamps |
| 5 | Dome Lamp |
| 6 | Rear Compartment Lamp |
| 7 | Tail Lamp Assembly- Right |
| 8 | License Lamp |
| 9 | Tail Lamp Assembly- Left |
| 10 | Radio |
| 11 | Courtesy Lamp- LR Door (RR Similar) |
| 12 | Electronic PRNDL Module |
| 13 | Cigar Lighter |
| 14 | Courtesy Lamp- Driver Door (Front Passenger Similar) |
| 15 | Dimmer/ Rear Compartment Lid Release Switch |
| Callout | Component Name |
|---|---|
| 1 | Radio |
| 2 | Right Heated Seat/Traction Switch |
| 3 | Hazard Switch |
| 4 | Left Heated Seat/Fog Lamp Switch |
| 5 | Passlock Sensor |
| 6 | Ambient Light Sensor |
| 7 | Ignition Lock Cylinder Solenoid |
| 8 | Windshield Wiper/Washer Switch |
| 9 | Ignition Switch C1 |
| 10 | Headlamp/Turn Signal Switch |
| 11 | Ignition Switch C2 |
| 12 | Inflatable Restraint Steering Wheel Module Coil C4 |
| 13 | Instrument Panel Cluster (IPC) |
| 14 | Dimmer/Rear Compartment Lid Release Switch |
| 15 | Wheel Speed Conditioner Module |
| 16 | Cruise/ Brake Switch |
| 17 | Fuse Block - I/P - Left |
| 18 | C207 |
| 19 | Data Link Connector (DLC) |
| 20 | C215 |
| 21 | Accelerator Pedal Position (APP) Sensor |
| 22 | Cruise Control Module |
| 23 | C215 |
| 24 | C205 |
| 25 | I/P Compartment Lamp |
| 26 | Body Control Module (BCM) |
| 27 | C204 (w/o UE1) |
| 28 | C204 (w/ UE1) |
| 29 | Fuse Block - I/P - Right |
| 30 | C200 Body Harness Side |
| 31 | C200 Headliner Harness Side |
| 32 | Inflatable Restraint I/P Module |
| Callout | Component Name |
|---|---|
| 1 | Cruise Set/Resume Switch |
| 2 | Cruise On/Off Switch |
| 3 | Stop Lamp Switch |
| 4 | Cruise Brake Switch |
| 5 | Cruise Clutch Switch (M/T) (Not Used) |
| 6 | Cruise Control Module (CCM) (Not Used) |
| Callout | Component Name |
|---|---|
| 1 | Door Jamb Switch - LR - RR Similar |
| 2 | Inflatable Restraint Side Impact Sensor (SIS) - Left Connector - Right Similar) |
| 3 | C800 - C700 Similar |
| Callout | Component Name |
|---|---|
| 1 | Tail Lamp Assembly-Left (Right Similar) |
| 2 | Park/Turn Signal Lamp-LF |
| 3 | Left Headlamp Assembly |
| 4 | Fog Lamp-Left |
| 5 | Fog Lamp-Right |
| 6 | Horn (Behind Fascia) |
| 7 | Right Headlamp Assembly |
| Callout | Component Name |
|---|---|
| 1 | Ambient Light Sensor |
| 2 | Windshield Wiper/Washer Switch |
| 3 | Left Heated Seat/Fog Lamp Switch |
| 4 | Hazard Switch |
| 5 | Right Heated Seat/Traction Switch |
| 6 | Radio |
| 7 | HVAC Control Module |
| 8 | Headlamp/Turn Signal Switch |
| 9 | Dimmer/Rear Compartment Lid Release Switch |
| 10 | Instrument Panel Cluster (IPC) |
| 11 | Ignition Lock Cylinder Solenoid |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.