Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006COBALT SS, 4D SEDAN, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 699 (ENGINE CONTROL SYSTEM & FUEL SYSTEM - 2.2L (L61) - TROUBLESHOOTING & DIAGNOSIS)INSPECTION/MAINTENANCE (I/M) COMPLETE SYSTEM SET PROCEDURECONDITIONS FOR MEETING A COLD START
2006 Chevrolet Cobalt SS, 4D Sedan, Standard
Conditions for Meeting a Cold Start
2006 Chevrolet Cobalt SS, 4D Sedan, StandardSECTION Conditions for Meeting a Cold Start
WARNING: This page is about a different car, the 2008 Pontiac G5 and 2008 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
- The ignition voltage between 11-18 volts.
- The barometric pressure (BARO) is more than 75 kPa.
- The start-up engine coolant temperature (ECT) is between 4-30°C (39-86°F).
- The start-up intake air temperature (IAT) is between 4-30°C (39-86°F).
- The difference between the IAT and the ECT is less than 6°C (10.8°F)
- The ambient air temperature is between 4-30°C (39-86°F).
- The fuel level is between 15-85 percent.
- Vehicle has NOT been refueled since the last cold start ignition cycle.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.