Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Circuit/System Description
The steering angle sensor shares a 12-volt ignition supply voltage with the electronic brake control module (EBCM) and the yaw-rate/lateral sensor. The EBCM applies a ground to the steering angle sensor low reference circuit, which is shared with the yaw-rate/lateral sensor.
The steering angle sensor provides a serial data signal output to the EBCM that represents the steering wheel degree of rotation. The EBCM utilizes this signal to calculate the driver intended driving direction.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.