SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006COBALT SS, 4D SEDAN, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 668 (WIRING SYSTEMS AND POWER MANAGEMENT - COMPONENT VIEWS & COMPONENT CONNECTOR END VIEWS)COMPONENT CONNECTOR END VIEWSTURN SIGNAL/MULTIFUNCTION SWITCH X2
2006 Chevrolet Cobalt SS, 4D Sedan, Standard

Turn Signal/Multifunction Switch X2

2006 Chevrolet Cobalt SS, 4D Sedan, StandardSECTION Turn Signal/Multifunction Switch X2
WARNING: This page is about a different car, the 2008 Pontiac G5 and 2008 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Turn Signal/Multifunction Switch X2 Connector End View
GM845610Courtesy of GENERAL MOTORS CORP.
Turn Signal/Multifunction Switch X2

Pin Wire Circuit Function
A - - Not Used
B 0.35 BK/WH 651 Ground
C 0.35 BN 1356 Flash To Pass Switch Signal
D 0.35 PU 524 Headlamp Dimmer Switch High Beam Signal
E 0.35 PK/WH 1970 Headlamp Low Beam Relay Control
F 0.35 YE 10 Headlamp Switch Signal
G 0.35 YE/BK 1418 Left Turn Signal Switch Signal
H 0.35 D-GN/WH 1419 Right Turn Signal Switch Signal
J-K - - Not Used
Connector Part Information 
  • OEM: 15393435
  • Service: 88986438
  • Description: 10-Way F Micro-Pack 064 Series (GY)
Terminal Part Information 
  • Terminal/Tray: 12177007/19
  • Core/Insulation Crimp: E/2
  • Release Tool/Test Probe: 12180559-1/J-35616-64B (L-BU)
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.