SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006COBALT SS, 4D SEDAN, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 668 (WIRING SYSTEMS AND POWER MANAGEMENT - COMPONENT VIEWS & COMPONENT CONNECTOR END VIEWS)COMPONENT CONNECTOR END VIEWSINFLATABLE RESTRAINT FRONT PASSENGER PRESENCE SYSTEM (PPS) MODULE
2006 Chevrolet Cobalt SS, 4D Sedan, Standard

Inflatable Restraint Front Passenger Presence System (PPS) Module

2006 Chevrolet Cobalt SS, 4D Sedan, StandardSECTION Inflatable Restraint Front Passenger Presence System (PPS) Module
WARNING: This page is about a different car, the 2008 Pontiac G5 and 2008 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Inflatable Restraint Front Passenger Presence System (PPS) Module Connector End View
GM1550231Courtesy of GENERAL MOTORS CORP.
Inflatable Restraint Front Passenger Presence System (PPS) Module

Pin Wire Circuit Function
1 0.35 TN/BK 723 Passenger Air Bag On Indicator Control
2 0.35 L-GN 353 Passenger Air Bag Off Indicator Control
3 - - Not Used
4 0.35 D-BU 913 Passenger Seat Belt Tension Sensor Signal
5 0.35 BK/WH 1251 Ground
6 0.35 PK/WH 916 Passenger Presence Sensor Signal
7 0.35 D-BU/WH 918 5-Volt Reference
8 - - Not Used
9 0.35 PK 1339 Ignition 1 Voltage
10-13 - - Not Used
14 0.35 YE 914 Low Reference
15 0.35 YE/WH 917 Low Reference
16 0.35 PK/BK 915 5-Volt Reference
17 - - Not Used
18 0.35 PU 5018 Occupant Sensor Serial Data
Connector Part Information 
  • OEM: 15431682
  • Service: See Catalog
  • Description: 18-Way F Micro-Pack 100W Series Sealed (BK)
Terminal Part Information 
  • Pins: 1, 2, 4, 6, 7, 9, 14-16, 18
  • Terminal/Tray: Service With Terminated Lead
  • Core/Insulation Crimp: See Terminal Repair Kit
  • Release Tool/Test Probe: 12122523/J-35616-6 (BN)
  • Pins: 5
  • Terminal/Tray: See Terminal Repair Kit
  • Core/Insulation Crimp: See Terminal Repair Kit
  • Release Tool/Test Probe: See Terminal Repair Kit
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.