Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET2006COBALT SS, 4D SEDAN, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 661 (LIGHTING SYSTEMS)REPAIR INSTRUCTIONSFOG LAMP AIMINGAIMING PROCEDURE

2006 Chevrolet Cobalt SS, 4D Sedan, Standard

Aiming Procedure

2006 Chevrolet Cobalt SS, 4D Sedan, StandardSECTION Aiming Procedure

WARNING: This page is about a different car, the 2008 Pontiac G5 and 2008 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Locating Alignment Points On Target Screen

Courtesy of GENERAL MOTORS CORP.

Park the vehicle 7.6 m (25 ft) away from the target screen.
Measure from the center of the fog lamp to the ground line. Using this measurement, mark the horizontal centerline (2) of the fog lamp on the target screen directly in front of the vehicle.

Fig 2: View Of Adjustment Screw

Courtesy of GENERAL MOTORS CORP.

The adjustment screw (1) is located in the front fascia just above the fog lamp assembly.
Turn ON the fog lamps. The top of the fog lamp beam image (4) on the target screen should be 102 mm (4 in) below the center of the fog lamp lens height.
Adjust the fog lamp as required using the adjusting screw (1) on the front of the fog lamp.
Turn OFF the fog lamps.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.