Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006COBALT SS, 4D SEDAN, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 661 (LIGHTING SYSTEMS)DIAGNOSTIC INFORMATION AND PROCEDURESINTERIOR BACKLIGHTING MALFUNCTIONCIRCUIT/SYSTEM VERIFICATION
2006 Chevrolet Cobalt SS, 4D Sedan, Standard
Circuit/System Verification
2006 Chevrolet Cobalt SS, 4D Sedan, StandardSECTION Circuit/System Verification
WARNING: This page is about a different car, the 2008 Pontiac G5 and 2008 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition ON, command the Parking Lamps ON and OFF with a scan tool. The park lamps should turn ON and OFF when changing between the commanded states.
- If the park lamps do not turn ON and OFF when commanded, refer to Park Lamps Malfunction .
- Ignition ON, observe the scan tool IP Dimmer Switch parameter while operating the dimmer switch from high to low. The voltage parameter should change as the switch is activated.
- If the parameter does not change, refer to I/P Dimmer Switch Malfunction.
- Park lamps ON, command the Interior Dimming control ON and OFF with a scan tool. The interior backlighting should illuminate from high to low for all components controlled by the indicator dimming control circuit.
- If the backlighting does not operate as described, refer to Interior Backlighting Malfunction.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.