Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006COBALT SS, 4D SEDAN, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 656 (ENGINE CONTROLS AND FUEL - 2.0L - INTRODUCTION (2 OF 2))REPAIR INSTRUCTIONSENGINE CONTROL MODULE REPLACEMENT
2006 Chevrolet Cobalt SS, 4D Sedan, Standard
Engine Control Module Replacement
2006 Chevrolet Cobalt SS, 4D Sedan, StandardSECTION Engine Control Module Replacement
WARNING: This page is about a different car, the 2008 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
| Callout | Component Name |
|---|---|
| Preliminary Procedure: Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection . |
|
| 1 | Engine Control Module
NOTE:
In order to prevent any possible electrostatic discharge damage to the ECM, do not touch the connector pins or the soldered components on the circuit board. RENDER: 1.0x NO RELATED Recommended Tools & Savings Use the Manual With the Right HardwarePair factory procedures with proven DIY tools so the instructions are easier to execute. Affiliate disclosure: We may earn a commission at no extra cost to you. When to See a MechanicStop DIY work and contact a certified mechanic immediately if any of the following apply:
|