Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006COBALT SS, 4D SEDAN, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 649 (INSTRUMENT PANEL TRIM AND CONSOLE TRIM)REPAIR INSTRUCTIONSCONSOLE FRONT TRIM PLATE REPLACEMENT
2006 Chevrolet Cobalt SS, 4D Sedan, Standard
Console Front Trim Plate Replacement
2006 Chevrolet Cobalt SS, 4D Sedan, StandardSECTION Console Front Trim Plate Replacement
WARNING: This page is about a different car, the 2008 Pontiac G5 and 2008 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
| Callout | Component Name |
|---|---|
|
NOTE:
Refer to Fastener Notice
. Preliminary Procedure: Remove the console rear trim. Refer to Console Rear Trim Plate Replacement . |
|
| 1 | Floor Console Transmission Shifter Opening Plate Assembly Tip: Disconnect the electrical connectors. |
| 2 | Trim Plate Clip |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.