SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006COBALT SS, 4D SEDAN, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 611 (AUTOMATIC TRANSAXLE - 4T45-E - INTRODUCTION (2 OF 2))SPECIFICATIONSRANGE REFERENCE
2006 Chevrolet Cobalt SS, 4D Sedan, Standard

Range Reference

2006 Chevrolet Cobalt SS, 4D Sedan, StandardSECTION Range Reference
WARNING: This page is about a different car, the 2007 Pontiac G5 Pursuit, 2007 Pontiac G5, and 2007 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
Range Reference

Range Park/
Neutral		 Reverse D 3 2 1
Gear N R 1st 2nd 3rd 4th 1st 2nd 3rd 1st 2nd 3rd** 1st 2nd***
1-2 Shift Solenoid  ON ON ON OFF OFF ON ON OFF OFF ON OFF OFF ON OFF
2-3 Shift Solenoid  OFF OFF OFF OFF ON ON OFF OFF ON OFF OFF ON OFF OFF
2nd Clutch  - - - A A* A* - A A* - A A* - A
2nd Roller Clutch  - - - H O - - H O - H O - H
Int./4th 
Band 		 - - - - - A - - - - A - - A
Reverse Clutch  - A - - - - - - - - - - - -
Coast Clutch  - - - - - - A A A A A A A A
Input Sprag  - - H H H O H H H H H H H H
Direct Clutch  - - - - A A - - A - - A - -
Forward Clutch  - - A A A A* A A A A A A A A
Lo/Rev Band  A A - - - - - - - - - - A -
Lo Roller Clutch  - - H O O O H O O H O O H O
  • A = Applied
  • H = Holding
  • O = Overrunning
  • ON = The solenoid is energized
  • OFF = The solenoid is de-energized
  • * = Applied with no load
  • ** = Manual SECOND-THIRD gear is only available above approximately 100 km/h (62 mph)
  • *** = Manual FIRST-SECOND gear is only available above approximately 60 km/h (37 mph)
  • Manual FIRST-THIRD gear is also possible at high vehicle speed as a safety feature
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.