SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006COBALT SS, 4D SEDAN, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 607 (SEAT HEATING SYSTEM AND SEAT COOLING SYSTEM)REPAIR INSTRUCTIONSHEATED SEAT CONTROL MODULE REPLACEMENT - FRONT
2006 Chevrolet Cobalt SS, 4D Sedan, Standard

Heated Seat Control Module Replacement - Front

2006 Chevrolet Cobalt SS, 4D Sedan, StandardSECTION Heated Seat Control Module Replacement - Front
WARNING: This page is about a different car, the 2007 Pontiac G5 Pursuit, 2007 Pontiac G5, and 2007 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Heated Seat Control Module -- Front
GM1549363Courtesy of GENERAL MOTORS CORP.
Heated Seat Control Module Replacement - Front

Callout Component Name
Fastener Tightening Specifications:  Refer to Fastener Tightening Specifications .
1 Seat Heater Module Assembly
Tip: 
  • Disconnect the electrical connectors.
  • The heater module is located in the passenger seat.
Refer to Control Module References for programming and setup information.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.