Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006COBALT SS, 4D SEDAN, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 601 (CRUISE CONTROL SYSTEM)COMPONENT LOCATORCRUISE CONTROL COMPONENT VIEWS
2006 Chevrolet Cobalt SS, 4D Sedan, Standard
Cruise Control Component Views
2006 Chevrolet Cobalt SS, 4D Sedan, StandardSECTION Cruise Control Component Views
WARNING: This page is about a different car, the 2007 Pontiac G5 Pursuit, 2007 Pontiac G5, and 2007 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
| Callout | Component Name |
|---|---|
| 1 | Turn Signal/Multifunction Switch |
| 2 | Inflatable Restraint Steering Wheel Module Coil |
| 3 | Windshield Wiper/Washer Switch |
| 4 | Steering Wheel |
| 5 | Steering Wheel Controls - Right (UK3/K34) |
| 6 | Horn Switchs |
| 7 | Steering Wheel Controls - Left (UK3/K34) |
| 8 | Electronic Power Steering Control Module (EPS) |
| 9 | Electronic Power Steering (EPS) Control Motor |
| 10 | Ignition Switch |
| 11 | Ignition Lock Cylinder Control Solenoid (MN5) |
| Callout | Component Name |
|---|---|
| 1 | Clutch Pedal Position (CCP) Switch (M86) |
| 2 | Clutch Start Switch (M86) |
| 3 | Stop Lamp/TCC Switch |
| 4 | Cruise Control Cancel Switch (M86) |
| 5 | Accelerator Pedal Position (APP) Sensor |
| 6 | Floor Pan |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.