SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006COBALT SS, 4D SEDAN, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 580 (POWER STEERING SYSTEM)COMPONENT LOCATORPOWER STEERING CONNECTORSELECTRONIC POWER STEERING (EPS) CONTROL MODULE C2
2006 Chevrolet Cobalt SS, 4D Sedan, Standard

Electronic Power Steering (EPS) Control Module C2

2006 Chevrolet Cobalt SS, 4D Sedan, StandardSECTION Electronic Power Steering (EPS) Control Module C2
WARNING: This page is about a different car, the 2007 Pontiac G5 Pursuit, 2007 Pontiac G5, and 2007 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Power Steering Control Module (PSCM) C2 Connector
GM1413003Courtesy of GENERAL MOTORS CORP.
Electronic Power Steering (EPS) Control Module C2 Connector & Terminal Parts Information

Connector Part Information 
  • OEM: 15438391
  • Service: 88988409
  • Description: 6-Way F 040 (GY)
Terminal Part Information 
  • Terminal/Tray: 173681-2/17
  • Core/Insulation Crimp: E/4
  • Release Tool/Test Probe: 15315247/J-35616-16 (L-GN)
Electronic Power Steering (EPS) Control Module C2 Terminal Identification

Pin Wire Color Circuit No. Function
1 TN/BK 2500 High Speed GMLAN Serial Data Bus (+)
2 TN 2501 High Speed GMLAN Serial Data Bus (-)
3 - - Not Used
4 BN/WH 2500 High Speed GMLAN Serial Data Bus (+)
5 BN 2501 High Speed GMLAN Serial Data Bus (-)
6 PK 1539 Ignition 1 Voltage
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.