Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006COBALT SS, 4D SEDAN, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 576 (LIGHTING SYSTEMS)COMPONENT LOCATORLIGHTING SYSTEMS CONNECTORSTURN SIGNAL/MULTIFUNCTION SWITCH C2
2006 Chevrolet Cobalt SS, 4D Sedan, Standard
Turn Signal/Multifunction Switch C2
2006 Chevrolet Cobalt SS, 4D Sedan, StandardSECTION Turn Signal/Multifunction Switch C2
WARNING: This page is about a different car, the 2007 Pontiac G5 Pursuit, 2007 Pontiac G5, and 2007 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
Turn Signal/Multifunction Switch C2 Connector & Terminal Parts Information
Connector Part Information
|
Terminal Part Information
|
Turn Signal/Multifunction Switch C2 Terminal Identification
| Pin | Wire Color | Circuit No. | Function |
|---|---|---|---|
| A | - | - | Not Used |
| B | BK/WH | 651 | Ground |
| C | BN | 1356 | Flash To Pass Switch Signal |
| D | PU | 524 | Headlamp Dimmer Switch High Beam Signal |
| E | PK/WH | 1970 | Headlamp Low Beam Relay Control |
| F | YE | 10 | Headlamp Switch Signal |
| G | YE/BK | 1418 | Left Turn Signal Switch Signal |
| H | D-GN/WH | 1419 | Right Turn Signal Switch Signal |
| J-K | - | - | Not Used |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.