SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006COBALT SS, 4D SEDAN, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 566 (SUPPLEMENTAL INFLATABLE RESTRAINT SYSTEM)REPAIR INSTRUCTIONSINFLATABLE RESTRAINT ROOF RAIL MODULE REPLACEMENT - FRONT
2006 Chevrolet Cobalt SS, 4D Sedan, Standard

Inflatable Restraint Roof Rail Module Replacement - Front

2006 Chevrolet Cobalt SS, 4D Sedan, StandardSECTION Inflatable Restraint Roof Rail Module Replacement - Front
WARNING: This page is about a different car, the 2007 Pontiac G5 Pursuit, 2007 Pontiac G5, and 2007 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Inflatable Restraint Roof Rail Module
GM1544635Courtesy of GENERAL MOTORS CORP.
Inflatable Restraint Roof Rail Module Replacement - Front

Callout Component Name

Preliminary Procedures

  1. Disable the supplemental inflatable restraint (SIR) system. Refer to SIR Disabling and Enabling .
  2. Remove the headliner. Refer to Headlining Trim Panel Replacement .
1 Inflatable Restraint Roof Rail Module Screw
NOTE: Refer to Fastener Notice .

Tighten:  8 N.m (71 lb in)
2 Inflatable Restraint Roof Rail Module Bolt

Tighten:  8 N.m (71 lb in)
3 Inflatable Restraint Roof Rail Module Bolt

Tighten:  8 N.m (71 lb in)
4 Inflatable Restraint Roof Rail Module Retainer (Qty: 3)
5 Inflatable Restraint Roof Rail Module Bolt

Tighten:  8 N.m (71 lb in)
6 Inflatable Restraint Roof Rail Module Assembly
Tip: 
  1. Remove the connector position assurance (CPA) retainer.
  2. Disconnect the electrical connector.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.