Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006COBALT SS, 4D SEDAN, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 560 (WARNINGS AND CAUTIONS)
2006 Chevrolet Cobalt SS, 4D Sedan, Standard
Section 560 (Warnings And Cautions)
2006 Chevrolet Cobalt SS, 4D Sedan, StandardSECTION Section 560 (Warnings And Cautions)
WARNING: This page is about a different car, the 2007 Pontiac G5 Pursuit, 2007 Pontiac G5, and 2007 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
- Introduction
- Definition of Caution, Notice, and Important
- Approved Equipment for Collision Repair Caution
- Assistant Driving Caution
- Battery Disconnect Caution
- Bleed Procedure Caution
- Brake Dust Caution
- Brake Fluid Irritant Caution
- Checking Hot Transmission Fluid through Drain Plug Hole Caution
- Collision Sectioning Caution
- Eye Protection Caution
- Gasoline/Gasoline Vapors Caution
- Glass and Sheet Metal Handling Caution
- Halogen Bulb Caution
- Moving Parts and Hot Surfaces Caution
- Road Test Caution
- Safety Glasses Caution
- SIR Caution
- SIR Deployed Inflator Modules Are Hot Caution
- SIR Inflatable Module Deployment Outside Vehicle Caution
- SIR Inflator Module Coil Caution
- SIR Inflator Module Disposal Caution
- SIR Inflator Module Handling and Storage Caution
- SIR Special Tool Caution
- Vehicle Lifting Caution
- Window Retention Caution
- Work Stall Test Caution
- Belt Dressing Notice
- Brake Fluid Effects on Paint and Electrical Components Notice
- Clean, Dry, Low Pressure Gas Source Notice
- Clearcoat/Ultraviolet Screeners Notice
- Component Fastener Tightening Notice
- Excessive Force and Oxygen Sensor Notice
- Fastener Notice
- Heated Oxygen and Oxygen Sensor Notice
- Heated Oxygen Sensor Resistance Learn Reset Notice
- OBDII Symbol Description Notice
- Silicon Contamination of Heated Oxygen Sensors Notice
- Test Probe Notice
- Three-Way Catalytic Converter Damage Notice
- Transmission Fluid Vent Cap Removal Notice
- Window Edge Damage Notice
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.