Circuit/System Testing: Notes

2006 Chevrolet Cobalt SS, 4D Sedan, StandardSECTION Notes
WARNING: This page is about a different car, the 2007 Chevrolet Monte Carlo and 2007 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.

Electrical System Testing

  1. If DTCs P3401, P3425, P3441, or P3449 are set, refer to DTC P3401, P3425, P3441, or P3449Β .
  2. Ignition ON, the engine OFF, command each VLOM solenoid ON and OFF using the scan tool output control function. While standing next to the engine compartment, you should be able to hear the solenoid energize and de-energize with each scan tool output control command.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.