Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006COBALT SS, 4D SEDAN, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 546 (ENGINE CONTROLS AND FUEL - 3.5L - DTC P0412 TO DTC P2544)DTC P0446CIRCUIT/SYSTEM TESTING
2006 Chevrolet Cobalt SS, 4D Sedan, Standard
Circuit/System Testing
2006 Chevrolet Cobalt SS, 4D Sedan, StandardSECTION Circuit/System Testing
WARNING: This page is about a different car, the 2007 Chevrolet Monte Carlo and 2007 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
Refer to the J 41413-200
operation manual for detailed instructions. See Special Tools
.
- Inspect the EVAP vent system for a restriction.
- Test the low reference circuit of the FTP sensor for an open or for high resistance.
- Start the engine with the J 41413-200 connected to the fuel filler neck. See Special Tools .
- Allow the engine to idle.
- Use the Purge/Seal function to seal the system with a scan tool.
- Command the EVAP canister purge solenoid valve to 30 percent.
- Observe the vacuum/pressure gage on the J 41413-200 and the FTP parameter on the scan tool. See Special Tools .
- Allow the vacuum to increase on the gage of the J 41413-200
until it reaches approximately 16 inches H2O, or until the vacuum reached the abort limit on the scan tool. See Special Tools
.
- If the difference between the FTP parameter on a scan tool and the vacuum/pressure gage on the J 41413-200 was more than 1 inch, replace the FTP sensor. See Special Tools .
- If the Fuel Tank Pressure Sensor parameter on a scan tool display was less than 3.2 volts, replace the FTP sensor.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.