Body Control Module (BCM) C4

2006 Chevrolet Cobalt SS, 4D Sedan, StandardSECTION Body Control Module (BCM) C4
WARNING: This page is about a different car, the 2007 Chevrolet Monte Carlo and 2007 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Body Control Module (BCM) C4 Connector End Views
GM1664499Courtesy of GENERAL MOTORS CORP.
Body Control Module (BCM) C4 Connector Parts Information

Connector Part Information 
  • OEM: 15482792
  • Service: See Catalog
  • Description: 25-Way F Receptacle 0.64 2.8 (BK)
Terminal Part Information 
  • Pins: 1, 2, 3, 4, 5
  • Terminal/Tray: SNAC-A061T-M2.8/20
  • Core/Insulation Crimp: E/A
  • Release Tool/Test Probe: 12094429/J-35616-4A (PU)
  • Pins: 7, 9, 10, 11, 12, 13, 15, 16, 17, 19, 21, 23
  • Terminal/Tray: SNAC3-A021T-M0.64/20
  • Core/Insulation Crimp: J/J
  • Release Tool/Test Probe: 12094429/J-35616-64A (L-BU)
Body Control Module (BCM) C4 Connector Terminal Identification

Pin Wire Color Circuit No. Function
1 RD/WH 340 Battery Positive Voltage
2 RD/WH 240 Battery Positive Voltage
3 RD/WH 440 Battery Positive Voltage
4 RD/WH 1240 Battery Positive Voltage
5 D-BU/WH 1315 Right Front Turn Signal Lamp Supply Voltage
6 - - Not Used
7 YE 196 Windshield Wiper Motor Park Switch Signal
8 - - Not Used
9 BK 50 Ground
10 RD/WH 2440 Battery Positive Voltage
11 D-GN/WH 1317 Fog Lamp Relay Control (T96)
12 YE 5187 Right Trailer Turn Signal Lamp (6J6)
13 OG 5186 Left Trailer Turn Signal Lamp (6J6)
14 - - Not Used
15 OG 2268 Windshield Washer Relay Control
16 TN/WH 1969 Headlamp High Beam Relay Control
17 PK/BK 109 Hood Ajar Switch Signal
18 - - Not Used
19 D-BU 5985 Accessory Wakeup Serial Data
20 - - Not Used
21 YE 5199 Run/Crank Relay Coil Control
22 - - Not Used
23 PU 544 DRL PCB Relay Control
24-25 - - Not Used
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.