SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006COBALT SS, 4D SEDAN, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 529 (DATA COMMUNICATION SYSTEM)COMPONENT LOCATORDATA COMMUNICATION COMPONENT VIEWS
2006 Chevrolet Cobalt SS, 4D Sedan, Standard

Data Communication Component Views

2006 Chevrolet Cobalt SS, 4D Sedan, StandardSECTION Data Communication Component Views
WARNING: This page is about a different car, the 2007 Chevrolet Monte Carlo and 2007 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Steering Column & Supplemtal Inflatable Restraints
GM1700238Courtesy of GENERAL MOTORS CORP.
Callout Component Name
1 I/P Carrier
2 Inflatable Restraint Steering Wheel Module
3 Steering Column
4 Body Control Module (BCM)
Fig 2: View Of I/P Harness - Front Of I/P Carrier
GM1568592Courtesy of GENERAL MOTORS CORP.
Callout Component Name
1 I/P Carrier
2 G202
3 G201
4 G200
5 G204 (9C1, 9C3)
6 C210
7 Spot Lamp - Right Connector (9C1, 9C3)
8 Fuse Block - I/P C2
9 C360 (9C1 and 9C3)
10 C362 (9C1 and 9C3)
11 C200
12 C267 (9C1 and 9C3)
13 C266 (9C1 and 9C3)
14 C297 (9C1 and 9C3)
15 HVAC Control Module C2
16 Splice Pack SP205
17 Splice Pack SP 206 and Splice Pack SP207
18 C201
19 Data Link Connector (DLC)
20 C203
21 C250
Fig 3: Exploded View Of Lower Left Side of I/P
GM1715330Courtesy of GENERAL MOTORS CORP.
Callout Component Name
1 G301
2 C223 - Taped to Harness (9C1,9C3)
3 C250
4 C203
5 Terminator Resistor-Taped to Harness (w/o UE1)
Fig 4: Identifying Left Side of Rear Compartment
GM1696879Courtesy of GENERAL MOTORS CORP.
Callout Component Name
1 Vehicle Communication Interface Module (VCIM) (UE1)
2 Backup Battery (UE1 Late Production)
3 Terminator Resistor (w/UE1)
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.