Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006COBALT SS, 4D SEDAN, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 520 (REAR SUSPENSION SYSTEM)SPECIFICATIONSFASTENER TIGHTENING SPECIFICATIONS
2006 Chevrolet Cobalt SS, 4D Sedan, Standard
Fastener Tightening Specifications
2006 Chevrolet Cobalt SS, 4D Sedan, StandardSECTION Fastener Tightening Specifications
WARNING: This page is about a different car, the 2007 Chevrolet Monte Carlo and 2007 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
Fastener Tightening Specifications
| Application | Specification | |
|---|---|---|
| Metric | English | |
| Brake Hose Bracket Bolt | 10 N.m | 89 lb in |
| Rear Strut Mount to Body Nuts | 45 N.m | 33 lb ft |
| Rear Strut Rod to Strut Mount Nut | 75 N.m | 55 lb in |
| Rear Strut to Knuckle Nuts | 120 N.m | 89 lb ft |
| Rear Suspension Support Mounting Bolts | 110 N.m | 81 lb ft |
| Rear Wheel Hub/Bearing to Knuckle Bolts | 75 N.m | 55 lb ft |
| Spindle Rods to Knuckle Nuts | 150 N.m | 111 lb ft |
| Spindle Rod to Rear Support Bolts | 135 N.m | 100 lb ft |
| Stabilizer Shaft Bracket Nuts | 48 N.m | 35 lb ft |
| Stabilizer Shaft Link Nuts (Lower) | 50 N.m | 37 lb ft |
| Stabilizer Shaft Link Nuts (Upper) | 52 N.m | 38 lb ft |
| Trailing Arm to Body Bracket Bolt | 105 N.m | 77 lb ft |
| Trailing Arm Bracket to Body Bolts | 52 N.m | 38 lb ft |
| Trailing Arm to Knuckle Bolt | 240 N.m | 177 lb ft |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.