SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006COBALT SS, 4D SEDAN, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 518 (SECONDARY AND CONFIGURABLE CUSTOMER CONTROLS)REPAIR INSTRUCTIONSSTEERING WHEEL CONTROL SWITCH ASSEMBLY REPLACEMENT
2006 Chevrolet Cobalt SS, 4D Sedan, Standard

Steering Wheel Control Switch Assembly Replacement

2006 Chevrolet Cobalt SS, 4D Sedan, StandardSECTION Steering Wheel Control Switch Assembly Replacement
WARNING: This page is about a different car, the 2007 Chevrolet Monte Carlo and 2007 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Replacing Steering Wheel Control Switch Assembly
GM1602793Courtesy of GENERAL MOTORS CORP.
Steering Wheel Control Switch Assembly Replacement

Callout Component Name
NOTE: Refer to Fastener Notice .
Preliminary Procedure: Remove the inflatable restraint steering wheel module. Refer to Inflatable Restraint Steering Wheel Module Replacement .
1 Bolt/Screw, Steering Wheel Switch
Tip:  Disconnect the electrical connector.

Tighten:  2 N.m (18 lb in)
2 Switch Assembly, Radio, HVAC and Cruise Control Assembly
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.