Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006COBALT SS, 4D SEDAN, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 514 (WIPER SYSTEM & WASHER SYSTEM)DIAGNOSTIC INFORMATION AND PROCEDURESSCAN TOOL OUTPUT CONTROLS
2006 Chevrolet Cobalt SS, 4D Sedan, Standard
Scan Tool Output Controls
2006 Chevrolet Cobalt SS, 4D Sedan, StandardSECTION Scan Tool Output Controls
WARNING: This page is about a different car, the 2007 Chevrolet Monte Carlo and 2007 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
Scan Tool Output Controls
| Scan Tool Output Control | Additional Menu Selection | Description |
|---|---|---|
| Wiper High Speed Relay | Computer Integrating Systems / Special Functions / Body Control Module / Miscellaneous Test | This output control of the body control module (BCM) commands the wiper high speed relay On or Off. |
| Wiper Relay | Computer Integrating Systems / Special Functions / Body Control Module / Miscellaneous Test | This output control commands the wiper relay On and Off. The wiper motor will operate at Low speed when the wiper relay is On. |
| Wiper Washer Motor | Computer Integrating Systems / Special Functions / Body Control Module / Miscellaneous Test | This output control commands the wind shield washer relay On and Off. The washer fluid pump will operate until you select Off. |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.