Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006COBALT SS, 4D SEDAN, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 514 (WIPER SYSTEM & WASHER SYSTEM)COMPONENT LOCATORWIPER/WASHER COMPONENT VIEWS
2006 Chevrolet Cobalt SS, 4D Sedan, Standard
Wiper/Washer Component Views
2006 Chevrolet Cobalt SS, 4D Sedan, StandardSECTION Wiper/Washer Component Views
WARNING: This page is about a different car, the 2007 Chevrolet Monte Carlo and 2007 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
| Callout | Component Name |
|---|---|
| 1 | Mass Air Flow (MAF)/Intake Air Temperature (IAT) Sensor |
| 2 | Brake Booster Vacuum Sensor (LS4) |
| 3 | Windshield Wiper Motor |
| 4 | Electronic Brake Control Module (EBCM) |
| 5 | A/C Refrigerant Pressure Sensor |
| 6 | Transmission Control Module (TCM) |
| 7 | Engine Control Module (ECM) |
| 8 | G101 |
| 9 | Inflatable Restraint Front End Sensor - Left |
| Callout | Component Name |
|---|---|
| 1 | Fuse Block - Underhood |
| 2 | Generator |
| 3 | Brake Fluid Level Switch |
| 4 | Battery |
| 5 | Inflatable Restraint Front End Sensor - Right |
| 6 | G100 |
| 7 | Horn Assembly |
| 8 | Windshield Washer Fluid Container |
| 9 | Windshield Washer Fluid Level Switch |
| 10 | Windshield Washer Fluid Pump |
| 11 | Battery Current Sensor |
| 12 | G102 |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.