Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006COBALT SS, 4D SEDAN, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 5 (CRUISE CONTROL SYSTEM)REPAIR INSTRUCTIONSCRUISE RELEASE SWITCH REPLACEMENTREMOVAL PROCEDURE
2006 Chevrolet Cobalt SS, 4D Sedan, Standard
Removal Procedure
2006 Chevrolet Cobalt SS, 4D Sedan, StandardSECTION Removal Procedure
WARNING: This page is about a different car, the 2005 Saturn L300. However, it is still accessible from the selected car via links, so may be relevant.
- Turn the ignition OFF.
- Remove the left side lower instrument panel (I/P) closeout panel (hush panel) push pin fasteners and remove the panel.
- Remove the left side lower heater duct assembly push pin fastener and remove the duct.
- Disconnect the cruise brake switch harness connector.
- Remove the cruise brake switch by rotating it to 180 degrees so it will pull out from the bracket.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.