Removal Procedure

2006 Chevrolet Cobalt SS, 4D Sedan, StandardSECTION Removal Procedure
WARNING: This page is about a different car, the 2005 Saturn L300. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Sunroof Motor/Actuator Electrical Connector
    GM861204Courtesy of GENERAL MOTORS CORP.
  1. Remove the headliner. Refer to Headliner Replacement (Wagon) or Headliner Replacement (Sedan) in Interior Trim.
  2. Disconnect the electrical connector on the sunroof actuator.
  3. Disconnect the electrical connector from the sunroof module.
  4. Fig 2: View Of Sunroof Front Drain Hose
    GM893482Courtesy of GENERAL MOTORS CORP.
  5. Disconnect the drain hoses from the drain spouts on the front sunroof.
  6. Fig 3: View Of Sunroof Rear Drain Hose
    GM893483Courtesy of GENERAL MOTORS CORP.
  7. Disconnect the drain hoses from the drain spouts on the rear sunroof module.
  8. Fig 4: View Of Sunroof Module Assembly
    GM861206Courtesy of GENERAL MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.