SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006COBALT SS, 4D SEDAN, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 48 (AUTOMATIC TRANSAXLE - INTRODUCTION & REPAIR INSTRUCTIONS)REPAIR INSTRUCTIONSSHIFT CONTROL CABLE REPLACEMENT - FLOOR SHIFTINSTALLATION PROCEDURE
2006 Chevrolet Cobalt SS, 4D Sedan, Standard

Installation Procedure

2006 Chevrolet Cobalt SS, 4D Sedan, StandardSECTION Installation Procedure
WARNING: This page is about a different car, the 2005 Saturn L300. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing & Installing Shift Control Cable From Vehicle
    GM893234Courtesy of GENERAL MOTORS CORP.
  1. Guide the control cable through the pass-through in the dash panel.
  2. Secure the control cable grommet by pressing the cable into the pass-through hole in the dash panel.
    3. Fig 2: Removing & Installing Shift Control Cable From Transaxle Range Switch Lever
    GM893827Courtesy of GENERAL MOTORS CORP.
  3. Route the control cable through the cable bracket on the powertrain mount, and secure the cable into the bracket.
  4. Install the control cable retaining clip.
    5. Fig 3: Removing & Installing Shift Control Cable From Control Assembly
    GM893834Courtesy of GENERAL MOTORS CORP.
  5. Connect the control cable end to the control assembly lever.
  6. Connect the control cable to pin on the control assembly.
  7. Secure the control cable into the control assembly by pushing into place.
  8. Install the control cable retaining clip.
  9. Install the console. Refer to Console Replacement in Instrument Panel, Gages and Console.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.