SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006COBALT SS, 4D SEDAN, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 48 (AUTOMATIC TRANSAXLE - INTRODUCTION & REPAIR INSTRUCTIONS)REPAIR INSTRUCTIONSCHANNEL PLATE ASSEMBLY ASSEMBLE
2006 Chevrolet Cobalt SS, 4D Sedan, Standard

Channel Plate Assembly Assemble

2006 Chevrolet Cobalt SS, 4D Sedan, StandardSECTION Channel Plate Assembly Assemble
WARNING: This page is about a different car, the 2005 Saturn L300. However, it is still accessible from the selected car via links, so may be relevant.

Tools Required 

J 36850  TRANSJEL™. See Special Tools .

    Fig 1: Identifying Accumulator Piston Seals
    GM55115Courtesy of GENERAL MOTORS CORP.
  1. Assemble the new accumulator piston seals (30) on the three accumulator pistons (29).
  2. Install the 1-2 and 2-3 accumulator assist springs (47, 125).
  3. Install the accumulator pistons (29) into the channel plate over the guide pins. The pistons are identical. You can assemble the pistons in any of the three accumulator bores.
  4. In order to retain the pistons, apply J 36850  onto the piston seals. See Special Tools .
  5. Install the manual valve (800) into channel plate.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.