Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Circuit Description
The engine control module (ECM) has the ability to set a diagnostic trouble code (DTC) if the engine stalls when the ignition has not been turned OFF. This DTC may aid in intermittent diagnosis of a customer complaint of intermittent engine stall. The scan tool Failure Record information can be duplicated under the same stall conditions in an attempt to reproduce the occurrence. Since DTC P1599 is a type D DTC, the ECM will not command the malfunction indicator lamp (MIL) ON. This DTC can set due to a driver error. For example, a vehicle equipped with a manual transaxle in which the clutch was release too quickly causing the engine to stall, will set DTC P1599.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.