Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET2006COBALT SS, 4D SEDAN, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 430 (FRONT SUSPENSION SYSTEM)REPAIR INSTRUCTIONSWHEEL BEARING/HUB REPLACEMENT - FRONTINSTALLATION PROCEDURE

2006 Chevrolet Cobalt SS, 4D Sedan, Standard

Installation Procedure

2006 Chevrolet Cobalt SS, 4D Sedan, StandardSECTION Installation Procedure

WARNING: This page is about a different car, the 2006 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Wheel Bearing/Hub Assembly & Mounting Bolts

GM933099

Courtesy of GENERAL MOTORS CORP.

Install the wheel bearing/hub assembly to the steering knuckle.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the wheel bearing/hub mounting bolts.
Tighten: Tighten the bolts to 130 N.m (96 lb ft).

Fig 2: Front Wheel Drive Shaft Spindle & Nut

GM933045

Courtesy of GENERAL MOTORS CORP.

Install the wheel drive shaft spindle nut.
Tighten: Tighten the nut to 205 N.m (151 lb ft).

Fig 3: Wheel Speed Sensor Electrical Connector & Connector Bracket

GM931451

Courtesy of GENERAL MOTORS CORP.

Install the wheel speed sensor electrical connector to the mounting bracket, if equipped.

Fig 4: View Of Front Wheel Speed Sensor

GM926677

Courtesy of GENERAL MOTORS CORP.

Connect the wheel speed sensor electrical connector.

Fig 5: Front Brake Rotor

GM931367

Courtesy of GENERAL MOTORS CORP.

Install the front brake rotor. Refer to Brake Rotor Replacement in Disc Brakes.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.