SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006COBALT SS, 4D SEDAN, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 410 (ENGINE CONTROLS - 2.2L (L61) - INTRODUCTION (2 OF 2))REPAIR INSTRUCTIONSAIR CLEANER ASSEMBLY REPLACEMENTINSTALLATION PROCEDURE
2006 Chevrolet Cobalt SS, 4D Sedan, Standard

Installation Procedure

2006 Chevrolet Cobalt SS, 4D Sedan, StandardSECTION Installation Procedure
WARNING: This page is about a different car, the 2006 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Air Cleaner Assembly
    GM927717Courtesy of GENERAL MOTORS CORP.
  1. Install the air cleaner assembly into position.
  2. Install the air cleaner attachment bolt.

    Tighten:  Tighten the air cleaner-to-support bracket bolt 4 cylinder to 10 N.m (89 lb in).

    3. Fig 2: Identifying Outlet Resonator/Duct Assembly
    GM898897Courtesy of GENERAL MOTORS CORP.
  3. Position the outlet resonator/duct assembly.
  4. Connect the PCV fresh air vent hose assembly.
  5. Tighten the clamp at throttle body assembly.
  6. Position outlet resonator/duct assembly up with support bracket and install push-pin.
  7. Tighten the clamp at the air cleaner assembly.
    8. Fig 3: Connecting Intake Air Temperature (IAT) Sensor Connector
    GM951542Courtesy of GENERAL MOTORS CORP.
  8. Connect the intake air temperature (IAT) sensor connector.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.