Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006COBALT SS, 4D SEDAN, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 406 (CRUISE CONTROL SYSTEM)COMPONENT LOCATORCRUISE CONTROL CONNECTOR END VIEWS
2006 Chevrolet Cobalt SS, 4D Sedan, Standard
Cruise Control Connector End Views
2006 Chevrolet Cobalt SS, 4D Sedan, StandardSECTION Cruise Control Connector End Views
WARNING: This page is about a different car, the 2006 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
Cruise/Brake Switch
| Connector Part Information |
|
||
|---|---|---|---|
| Pin | Wire Color | Circuit Number | Function |
| A | PK | 1339 | Ignition 1 Voltage |
| B | PU | 420 | Cruise Control Release Signal |
Steering Wheel Control Switch - Left
| Connector Part Information |
|
||
|---|---|---|---|
| Pin | Wire Color | Circuit Number | Function |
| 1 | - | - | Not Used |
| 2 | GY | 397 | Cruise On/Off Switch Signal |
| 3 | GY | 8 | I/P Lamps Supply Voltage |
| 4 | PK | 1339 | Ignition 1 Voltage |
| 5 | GY/BK | 87 | Cruise Resume/Accel Switch Signal |
| 6 | D-BU | 84 | Cruise Set/Coast Switch Signal |
| 7 | BK/WH | 151 | Ground |
Steering Wheel Control Switch - Right
| Connector Part Information |
|
||
|---|---|---|---|
| Pin | Wire Color | Circuit Number | Function |
| 1 | BK/WH | 151 | Ground |
| 2 | WH/BK | 644 | 10-Volt Reference |
| 3 | GY | 8 | I/P Lamps Supply Voltage |
| 4 | D-BU | 1796 | Remote Radio Control Supply Voltage |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.