SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006COBALT SS, 4D SEDAN, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 403 (ENTERTAINMENT SYSTEM)REPAIR INSTRUCTIONSRADIO REPLACEMENTREMOVAL PROCEDURE
2006 Chevrolet Cobalt SS, 4D Sedan, Standard

Removal Procedure

2006 Chevrolet Cobalt SS, 4D Sedan, StandardSECTION Removal Procedure
WARNING: This page is about a different car, the 2006 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View of Radio & Screws
    GM977314Courtesy of GENERAL MOTORS CORP.
  1. Remove the I/P center trim bezel. Refer to Trim Bezel Replacement - Center in Instrument Panel, Gages, and Console.
  2. Remove the radio screws.
    3. Fig 2: View of Radio Electrical Connectors & Antenna
    GM977320Courtesy of GENERAL MOTORS CORP.
  3. Disconnect the radio electrical connectors and the antenna.Slightly push the antenna lead toward the radio to relieve tension on the internal fingers. Then pull back on the spring-loaded locking ring and remove the connector from the radio.
  4. Remove the radio.
    Fig 3: View of Ground Strap
    GM977328Courtesy of GENERAL MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.